|
|
 |
|
Huge 36" x 27" extruded aluminum Table gives you plenty of support for your largest workpieces3-5/8" dia. opening (without Insert Rings) accepts even your largest panel-raising bits.
Five pre-drilled holes for mounting Triton's 2-1/4 or 3-1/4 HP routers. Tops with no holes predrilled are available for other router types.2 Threaded holes for starter pin (included)
Table end tracks, each with two T-slots. One for 5/16" bolts w/1/2" hex heads-one for 3/8"-16 weld nuts.
Tabletop T-slots. Four accept 5/16" bolts w/1/2" hex heads-four accept standard 3/4" miter gauge bar w/or w/o T-slot washers. Great for jigs, fixtures, featherboards, etc.
INCLUDES:(8) twist-lock Insert Rings (Solid, 1/2",3/4",1",1-1/4",1-1/2",2",2-5/8" openings) w/Spanner Locking Wrench(3) Zero Clearance Fence Inserts(2) 5/16"-18 threaded Knobs Screw-in Starting Pin5/32" Allen driver.Nuts, bolts and assorted mounting hardware.16-page full-color instruction book, DVD 3 Router Table Made Easy and 48" x4-3/4" of easy-adjusting Fence to guide your stock through the cut.
Spring-loaded Pin allows rapid pivot adjustments of Fence from one end-or use Locking Knobs on both Fence ends if you prefer when working with cumbersome workpieces.
Fence can be swapped end-for-end, allowing work from either side of Table4-step Dust Port slides captive over full length of Fence in dovetail slots. Slide out of the way to access bit area for cleanout-accepts 1-1/4",1-1/2",2" & 2-1/4" I.D. fittings.
Three T-Slots for attaching stops, hold-downs or similar devices using 516" bolts w/1/2" hex heads. Another slot on Fence for mounting HDPE Sub-Fences.HDPE Sub-fences slide left to right and lock in T-slot...can be shimmed from behind for outfeed support when making full-height edge cuts.
Zero clearnce Fence Inserts (3 included w/Fence) can be customized to match your bits.
|
|
